感謝大家支持,開設26週年TANVIR.DEHANGFXAI.BIZ 創業慶

TANVIR.DEHANGFXAI.BIZ

詳細請見這裡
我的商店 我的商店 變更
  • 當日配送
  • 廣告
  • 可保留
  • 店舖取貨

高精度博立方PM2.9飛行控制器 升級版羅盤套餐 C+WIFI+數傳 V1 精準航拍 運動攝影

※TANVIR.DEHANGFXAI.BIZ 限定款式
YouTuber 為大家介紹商品的使用感受!
介紹影片請見這裡

網路販售
價格(含稅)

8636元

  • 登錄科梅利卡號並使用科梅利卡付款即可
    科梅利點數 : 268獲得點數

關於科梅利點數

減少購買數量
增加購買數量

到店取貨 到店取貨
(免運費)

取貨店舖:

選擇店舖

確認附近店舖

預計交貨時間:

13時前下單→17時前備妥

17時前下單→隔天早上前備妥

關於取貨方式與運費

加入購物車

配送 配送

預計交貨時間:

11月23日左右預計送達。

僅限信用卡或貨到付款。若使用其他付款方式,請這裡確認相關資訊。

※若於週末、國定假日下單,或因庫存狀況影響,商品送達可能需要較長時間。

關於當日出貨條件

關於取貨方式與運費

加入購物車

加入願望清單

已加入願望清單

高精度博立方PM2.9飛行控制器 升級版羅盤套餐 C+WIFI+數傳 V1 精準航拍 運動攝影的詳細資訊

  APM2.9 Flight Controller Note:Now the latest Mission planner 1.3.76 has bug ,it can not calibrate Accel for APM,Waiting for the official fix of this bug, please use version 1.3.74. APM2.9 is used in the same way as APM2.6, 2.8. The benefit is that APM 2.9 supports PPM or PWM receiver protocols. Why use the PPM protocol? The communication speed is fast, the wiring is simple, only one   needed, unlike each channel of the PWM, the PWM communication speed is slower than PPM/SBUS. The product supports the PPM receiver protocol and supports the PWM protocol. Before using this product, make sure your receiver is PPM-enabled. If your receiver does not support PPM, use the PWM protocol. Also, you can upload firmware from Mission Planner.Uploading firmware does not affect support for PPM. When connect INPUT 2 and 3(Insert Jumper),use PPM. when Disconnect INPUT 2 and 3(Remove Jumper) ,use PWM NOTE:The hardware of APM2.9 is same as APM2.8. Apm2.9 uses the PCB hardware of apm2.8. It\'s just that the code of the 32u2 chip is different.The 32u2 chip of apm2.9 supports PPM and PWM functions.   PackageD included: 1x APM2.9 flight controller board with shell(without Built-in compass ) 1x M8N GPS Moudule with shell(with external compass) 1x Shock absorber 1x GPS stand 1x RC receiver cable 1x Radio Telemetry(100mw.433MHZ,if need 915 MHZ, leave a message) 1x PWMRC Receiver Connection  /span> 1x PPMRC Receiver Connection  /span>   Radio telemetry V1     M8N GPS: Power Module: For PIXHAWK 2.4.8 :used for PIXHAWK2.4.8 AND APM2.8 Flight Control For PIXHAWK PRO :used for PIXHAWK PRO Flight Control For PIXHAWK 6C :used for PIXHAWK 6C Flight Control Description: This Power Module PRO provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection. Specification: Input Voltage: 2S-12S PCB Cont. Current Rating: 60A PCB Burst Current Rating: 100A (<60 Sec) Max Current Sensing: 120A Output: DC 5.2V & 3A Max Voltage Divider: 18.182 Amperes per Volt: 36.364 Weight: 20g Please Note: - The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. 商品備註・物品狀況:全新・最新關注時間:2026-10-15
  • 高精度博立方PM2.9飛行控制器 升級版羅盤套餐 C+WIFI+數傳 V1 精準航拍 運動攝影
  • 飛恩模型有限公司
  • 飛恩模型有限公司
  • 飛恩模型有限公司
  • 飛恩模型有限公司
  • 飛恩模型有限公司
  • H1飞控磁罗盘校准- YouTube
  • DJI – 官方網站
  • Flywing ACE 直升機飛控FBL 陀螺儀H1 升級版,內建M10 GPS 與協調轉彎
  • 航拍機系列- DJI
  • DJI – 官方網站
  • DJI – 官方網站
  • 航拍機系列- DJI
  • 博鷹Paladin V2 - 農業無人機自動飛控系統– RCDrone
  • 飛恩模型有限公司
  • 航拍機系列- DJI

尋找相同分類的商品

暢銷商品排行榜

查看更多此分類商品

查看此商品的人也看了以下商品

附近賣場的商品

查看更多此分類商品

顧客評論

推薦度  4.4分

目前有 171則評論。